Dascom 7010 Peeler Installation and User Guide Uživatelský manuál stáhnout pdf (Strana 3)

Release knob

Peeler unit

Alignment holes and pins

(8) Attach the connector of the peeler unit to the daughter board as shown in the figure.

Note The connector cannot be connected if it is inserted in the wrong orientation

unless force is used!

Check the orientation of the connector carefully.

(9) Slide the release knob of the peeler unit to the left and open the peeler unit.

Daughter board

Connector

(10) After positioning the peeler unit on the printer using the alignment pins on the peeler

as a guide, fix the unit to the printer using the screw supplied. Then close the peeler.

Note Be careful not to pinch the wiring harness from the peeler unit.

Wiring harness

1 2 3 4

Žádné komentáře

Dascom 7010 Peeler Installation and User Guide Uživatelský manuál Strana 3