Dascom TallyCom III FSL Reference Manual Uživatelský manuál stáhnout pdf (Strana 20)

FSL Reference Manual for Print Servers

Appendix Section - FSL Commands for IBM 3270 emulation

T(est) Functions

Six different tests may be run via the line. Use the following syntax:

%T<test number>

Test Number Test

1 Offline HEX Dump

2 Online HEX Dump

3 ASCII HEX dump

4 Print out settings

5 Print out character sets

6 Cancel Test 3 (On-line ASCII HEX dump)

Test 4 can also be generated via the TEST key on the interface's rear panel. Test 3 is

terminated by pressing the TEST key on the rear panel.

Z Function (Sending user-defined strings)

This function is used for sending user-defined strings (up to 8 strings can be defined -

see FSL 61). Use the following syntax:

%Z<string number>

W Function (Bar code printing)

This function is used for sending bar codes (up to 8 bar codes can be defined - see FSL

59). Use the following syntax:

%W<no><barcode data>%

X Functions (Storing and restoring settings)

The X commands allow you to store the temporarily defined settings or to overwrite these

settings by reading the power up default settings. You may also restore the settings to

factory default.

%X1 Saves temporarily defined settings as power-up settings.

%X3 Reads and activates factory default settings.

%X4 Reads and activates power-up default settings.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Žádné komentáře

Dascom TallyCom III FSL Reference Manual Uživatelský manuál Strana 20